Introduction Of Feeder Footwear Machine

A kind of socks packaging machine parallel feeding mechanism, by flat plug cylinder (32), flat plate (33), left upper pressure belt (34), lower left press belt (35), left upper pressure belt motor (36), left bottom pressure belt motor (37), right progressive bag floating belt rack (38), right progressive bag floating flat belt (39), Right Down bag belt rack (40), the lower right inlet bag belt (41), the folding cylinder (43), The push Edge tooth (42), the folding shaft (80), the folding small flip plate (81), the folding duct (44), the suction cup (45) constitute, which is characterized by: flat plug cylinder (32) horizontal mounting on the rack, flat plug cylinder (32) The launch end is connected to the flat plate (33), the left upper pressure belt motor (36) and the left bottom press belt motor (37) are installed on the rack, driving the left upper pressure belt (34) and the left lower pressure belt (35) respectively, when the socks around the inner lining paper plate reach the left position of the parallel feeding mechanism, the flat plug cylinder (32) The introduction drives the flat Plate (33) to move to the right, directly into the middle crease position of the outer wrapping paper (25), the inner lining paper plate and the socks around it are transmitted simultaneously to the middle crease position of the outer wrapping paper (25), the outer wrapping paper (25) is driven to the right, and the outer wrapping paper (25) is wrapped in , which is incorporated between the left upper pressure belt (34) and the left lower pressure belt (35), the upper left press belt (34) and the Left Bottom press belt (35) are driven by the upper left press belt motor (36) and the left lower pressure belt motor (37), and the inner lining paper plate and the socks around it are flattened to the right; right progressive bag floating belt rack (38 ) mounted on the rack via a slide rail can float up and down, the right progressive bag floating flat belt (39), suction cup (45) are installed on the floating frame (38), the folding cylinder (43), the folding duct (44) are installed on the rack, the folding teeth (42) and the folding shaft (80) are installed on the rack, folding small flip plate (81) Mounted on the folding shaft (80), the folding cylinder (43) can push the folding tooth (42) to rotate, the folding tooth (42) to push the folding shaft (80) swing, the folding shaft (80) to drive the installation of the folding small flip plate (81) to flip and reset the action, wrap the outer wrapping paper socks into the right bag floating flat belt (39)and the right lower inlet bag belt (40) and transmits to the right, when the rear small edge to the folding small flip plate (81), the right into the bag floating flat belt (39) and the right lower bag belt (40) Stop, suction cup (45) suction, will be the most upper layer of outer wrapping paper suction, while the inside lining paper plate and around the socks to And the lowest level of outer wrapping paper is not sucked up, folding duct (44) suction down, the bottom of the outer wrapping paper is sucked close to the folding small flip plate (81), at this time the folding cylinder (43) to push the folding teeth (42) Rotation, folding teeth (42) to promote the folding shaft (80) Swing, folding shaft (80) drive the installation of the folding Small Flip Board (81 ) to flip, fold the small edges left out of the lower layer of outer wrapping paper to the top of the socks, fold the cylinder (43) Reset, drive the fold tooth (42) Reverse flip Reset, and eventually drive the folding small flip Plate (81) Reset, suction cup (45) and folding duct (44) stop suction, floating frame (38) drop, right into the bag floating flat 39) Under pressure, right into the bag floating flat belt (39) and right lower bag belt (40) rotation, clamping has been folded small edges of the socks continue to send to the right.