A single needle hosiery machine is a hosiery machine that weaves long, medium and short hosiery and pantyhose with one needle.
Can produce flat stitch, add yarn, set ring, jacquard, wool ring and horizontal strip and other organizations of socks. The main ring machine parts are tongue needle, settling piece, foot piece and jacquard piece. The heel of tongue needle is divided into long, medium and short. Generally, the long heel needle and the short heel needle are respectively arranged on the half circumference of the needle barrel. The tongue needle weaves by moving up and down in the groove of the needle barrel. The settling plate is between the tongue pins for radial entry and exit, and its function is to hold the coil when unwinding and pull the coil after forming a circle. The length of the coil is determined by the distance of the needle from the surface of the settling plate. The foot piece can transfer the motion to the tongue needle, and the jacquard piece has a multistage tooth to select the needle. After the needle is selected, the tongue needle runs in different routes,
To decide whether or not to take part in knitting. The upper and middle triangle of the triangle system of the hosiery machine and the left and right bending yarn triangle are symmetrical triangle seats, so the needle cylinder can be woven when it turns in one direction or two directions. The JACQUARD TRIANGLE ACTS ON THE HEEL OF THE JACQUARD PIECE, WHICH CAN MAKE THE TONGUE NEEDLE RISE TO THE UNWINDING height, PASS through the right bending YARN triangle, press down through the upper and middle triangle, and feed the yarn, and then descend along the left bending yarn triangle to form a new coil, remove the old coil, then rise along the panel, and finally form a coil. If the jacquard piece is pushed into the slot by the needle selection mechanism, it will not rise along the jacquard triangle, and the tongue needle will run in a lower position, and no yarn will be looped at this time.
The characteristics of the round hosiery machine are that it can weave the bag shaped hosiery heel and hosiery head in both directions. The knitting of socks is the same as that of the socks head, which is completed by a needle picker and a press needle. When the sock and start knitting, the needle on the sock surface stops working first. At this time, the needle cylinder turns into two-way rotation, and the left and right needle picker enters the work alternately. When the needle heel meets the needle picker, the needle picker picks a needle to the upper and middle triangle, so that it exits the work. After receiving a certain number of needles, press the needle into the work, so that the knitting needle to pull out of the work and then gradually participate in knitting, this is the process of needle release. When setting out the needles, press the needle device to press two needles each time, and the needle picker still lifts one needle, so that the number of needles involved in the work increases gradually. At the end of the needle release, the sock heel is formed. The sock head can also be braided by the above methods, but the closure of the sock head can be stitched in the later special process, and can also be stitched directly on the sock machine. It can also be completed by other means such as kinking and hot melting.
In some long, knee-socks, woven of the disc groove on the top of the cylinder with sox mouth hook, sox hook for radial in and out of the mouth movement, hooks in the front of the starting coil, and make the coil hiding retraction, when the single socks knitting enough length and folded into the double, socks mouth hook forward, will shift the starting coil on the latch needle and make the double layer socks or mouth. The action of knitting needle during opening and folding is completed by another triangular system.
